ofna x1 crt
#1
Thread Starter
My Feedback: (1)
Join Date: Oct 2009
Location: las vegas,
NV
Posts: 277
Likes: 0
Received 0 Likes
on
0 Posts
ofna x1 crt
i just got a very nice used ofna x1 crt, not sure of pro or rtr version. all i know is that when i put in my sh.28 motor the backplate/pullstart causes the engine to tilt foward. is there a set of mounts to fix this? do i have to run a motor with no pullstart? are there differences in the chassis between rtr and pro version?
#4
Senior Member
Join Date: Feb 2007
Location: Somerset, UNITED KINGDOM
Posts: 2,324
Likes: 0
Received 0 Likes
on
0 Posts
RE: ofna x1 crt
You could raise the engine or the mounts using flat washers...always ensure the screws are long enough to provide a reasonable amount of thread engagement.
#5
Thread Starter
My Feedback: (1)
Join Date: Oct 2009
Location: las vegas,
NV
Posts: 277
Likes: 0
Received 0 Likes
on
0 Posts
RE: ofna x1 crt
i tried that and now the engine is to close even at its farthest point away from the spur gear. i could open up the engine mounting oles on the chassis but that is not something i really want to do.
thanks for the tip though.
thanks for the tip though.