programing crow on a 9305 JR
#1
Senior Member
Thread Starter
My Feedback: (38)
Join Date: Dec 2001
Location: Spokane,
WA
Posts: 383
Likes: 0
Received 0 Likes
on
0 Posts
programing crow on a 9305 JR
Hi Guys
I have a new 9305 JR, need help on programing crow. Not sure what it is listed under. Would like to have it linked with the flaps and have it on a switch if I want to turn it off. It's all new to me !
Thanks
Charlie
I have a new 9305 JR, need help on programing crow. Not sure what it is listed under. Would like to have it linked with the flaps and have it on a switch if I want to turn it off. It's all new to me !
Thanks
Charlie
#2
Senior Member
RE: programing crow on a 9305 JR
I assume you mean 9503 and not 9305. If so, the 9503 and 9303 are the same for setup. I don't have time to find it right now but go to Horizon's website and somewhere in the support area you will find "Programming Guide for the JR XP9303 for the Hangar 9 Ultra Stick." The XP9303 is the same(set up wise) as the 9303/9503 and the directions will probably do what you want. It is the last step, "Flap to Aileron Mixing" that does what you want.
#6
RE: programing crow on a 9305 JR
I programmed in Crow for my Giant Big stick.
I'm quite pleased with the setup.
The key is to tell the TX that you are setting up a GLIDER, then follow the instructions for setting up a motorized glider.
The TX reconfigures the channel assignments to keep your servos in tight sync with each other. You'll have to move some connectors to the RX around, but it works great.
With a flip of a switch I can go from Outboard Ailerons only, Ailerons with normal flaps, Inboard and Outboard ailerons ( flaps as ailerons ), crow, and elevator to flaps.
I liked this so much that I set up most of my 3D planes the same way, as gliders.
I'm quite pleased with the setup.
The key is to tell the TX that you are setting up a GLIDER, then follow the instructions for setting up a motorized glider.
The TX reconfigures the channel assignments to keep your servos in tight sync with each other. You'll have to move some connectors to the RX around, but it works great.
With a flip of a switch I can go from Outboard Ailerons only, Ailerons with normal flaps, Inboard and Outboard ailerons ( flaps as ailerons ), crow, and elevator to flaps.
I liked this so much that I set up most of my 3D planes the same way, as gliders.