HS-85mg screw
#1
Senior Member
Thread Starter
Join Date: Sep 2006
Location: Southeastern,
OH
Posts: 239
Likes: 0
Received 0 Likes
on
0 Posts
HS-85mg screw
I've got an HS-85mg that I need the screw that goes in the output shaft to hold the arm in place. Does anybody know what size and threads the screw is and where to get one without buying a whole gear set?
Thanks
Thanks
#2
Senior Member
RE: HS-85mg screw
ORIGINAL: madman75 I've got an HS-85mg that I need the screw that goes in the output shaft to hold the arm in place.
Does anybody know what size and threads the screw is and where to get one without buying a whole gear set?
Thanks
Does anybody know what size and threads the screw is and where to get one without buying a whole gear set?
Thanks
extract
"Small machined screws, 2.3 x 5 mm Phillip-head (JIS) screws x 5, fit the HS-65MG, HS-81MG, HS-85MG, HS-125MG."
Much more information available below
"Radio Systems, Accessories, Alterations and FAQ" at
Alan's Hobby, Model & RC FAQ Web Links
Alan T.
#3
Senior Member
Thread Starter
Join Date: Sep 2006
Location: Southeastern,
OH
Posts: 239
Likes: 0
Received 0 Likes
on
0 Posts
RE: HS-85mg screw
Thanks for the size. I can't seem to find anybody that lists them. They must not be widely used. I've searched the net by the size but no luck.
#4
Senior Member
RE: HS-85mg screw
ORIGINAL: madman75 Thanks for the size. I can't seem to find anybody that lists them. They must not be widely used. I've searched the net by the size but no luck.
A direct link to the actual packet of screws was provided within post #2 under:
. Servo - Horn Screw - Hitec & Futaba Metal & Resin gear screw sizes
It is still shown as in stock...
Alan T.