Carson receiver pinout
#1
Junior Member
Thread Starter
Join Date: Nov 2012
Location: BillundDanmark, DENMARK
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
Carson receiver pinout
I have this Carson receiver and need to know which pins mst be connected for Battery.
As you see there are 6 x 3 pins, but which ones (two) are ground and plus?
As you see there are 6 x 3 pins, but which ones (two) are ground and plus?
#3
RE: Carson receiver pinout
http://www.carson-modelsport.com/Com...nanleitung.pdf
This is for a 3 chanel carson radio. The pin orientation should be the same. Page 21 Black wire is on the outside.
This is for a 3 chanel carson radio. The pin orientation should be the same. Page 21 Black wire is on the outside.
#4
Junior Member
Thread Starter
Join Date: Nov 2012
Location: BillundDanmark, DENMARK
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
RE: Carson receiver pinout
Must have expressed myself badly. Let's try again:
There are 6 channel sets of 3 pins, AND there is a set for BATT, which also have 3 pins.
I just need to know which 2 of these 3 pins I must connect power to. The connector to this receiver has 2 pins, so it is important to connect it correctly. I suppose that ground is towards the edge of the unit (???)
There are 6 channel sets of 3 pins, AND there is a set for BATT, which also have 3 pins.
I just need to know which 2 of these 3 pins I must connect power to. The connector to this receiver has 2 pins, so it is important to connect it correctly. I suppose that ground is towards the edge of the unit (???)