savage xs initial setup
#1
Senior Member
Thread Starter
Join Date: Jan 2009
Location: Portage la Prairiemanitoba, CANADA
Posts: 211
Likes: 0
Received 0 Likes
on
0 Posts
savage xs initial setup
just got a new xs for xmas and was wondering in what order do you do the setup, i did the failsafe setup and that seems to be working properly but when i connect my battery while im holding full throttle i do not get the beeping response from the esc, any help would be appreciated thanks so much. merry christmas btw!!!
#2
RE: savage xs initial setup
if i remember right it wont beep when your setting up your remote till you get the full throttle full reverse and neutral set then it beeps
look at the lights on the esc they should blink and change color as you set the throttle/reverse/neutral
green redorangish
look at the lights on the esc they should blink and change color as you set the throttle/reverse/neutral
green redorangish
#3
Senior Member
Thread Starter
Join Date: Jan 2009
Location: Portage la Prairiemanitoba, CANADA
Posts: 211
Likes: 0
Received 0 Likes
on
0 Posts
RE: savage xs initial setup
ok now one other question im not using a 2s or 3s battery i have those on order im plugging in a 4s battery could that be part of the problem im having? im not going to run the truck on it just wanted to get it setup so when my lipos get here i can sodder charge and run it, thanks for your post
#4
Senior Member
Join Date: Nov 2008
Location: , KY
Posts: 496
Likes: 0
Received 0 Likes
on
0 Posts
RE: savage xs initial setup
4s lipo may be the problem. That esc can only handle 3s max. It may be going into an overload protection and not allowing the ESC to arm. If you have a 6 cell nimh you might be able to get the ESC setup (calibrated) to the radio system. If you want to dig deeper into the ESC settings you can look into getting the Castle Link wiring harness and then download the Castle link freeware from castle creations website.