N1EDM

My Feedback: (2)

Hi,

I am probably making a mountain out of a mole hill, but I cannot figure out how to mix two elevator servos in P-MIX1.

Before anyone says anything, yes, I realize that I can use a Y-Cable but I don't want to. At this point, I would really like to know what I am doing wrong in programming the PMIX.

I have CH2 (elevator) as Master, and CH5 (Gear) as the slave (I have also tried using 7 as the slave with no difference)
Both RT's are st for +100 and the switch is set to ON and Null () so that this mix is always on.

At best I can get the CH2 elevator to function normally (as you would expect), but CH5 will only move in the follow in the Up direction.

I reset the Memory before I started programming, so nothing else should be hidden or out of kilter.

What am I doing wrong?

Thanks,

Bob

Krysta

It sounds as through your Gear switch is affecting your mix. So you would want to go into your Parameters menu and scrolling to the second page, make sure that channel 5 is set to Null.

Let us know if this helps.


Sincerely,
Krysta
Product Development & Support Specialist
Futaba Service Center USA
[email protected]

N1EDM

My Feedback: (2)

Bingo!! I never would have thought of that one, Krysta.

While on that page, I noticed that the same situation would have occurred for Channel 7. Thanks, that was it!!

Tell me, do you repair PC's too??

Thanks again,

Bob