Lithium Ion Pack @ 7.8 Fully Charged
#1
Senior Member
Thread Starter
Join Date: Jul 2012
Location: , CA
Posts: 433
Likes: 0
Received 0 Likes
on
0 Posts
Lithium Ion Pack @ 7.8 Fully Charged
Hi Y'all, charged a Li-ion pack and it showed fully charged on a balance charge at 7.8Volts on my hitec x4. I thought that 8.4 was fully charged. Is this pack blown? Appreciate any help you can provide.
#2
Senior Member
Thread Starter
Join Date: Jul 2012
Location: , CA
Posts: 433
Likes: 0
Received 0 Likes
on
0 Posts
RE: Lithium Ion Pack @ 7.8 Fully Charged
Oh forgot to mention another pack on balance charge is showing 8.2 with no increase in charge for alost an hour now. Problems or is this ok. I have a tester that can put a 1 to 3 amp load on it. Should I load test it at 1 amp and see how long I get on them? How can safely determine these packs are over the hill?
#4
RE: Lithium Ion Pack @ 7.8 Fully Charged
ORIGINAL: guver
Depending upon the termination voltage. Usually a Li-ion is 4.1 volts/cell when full.
Depending upon the termination voltage. Usually a Li-ion is 4.1 volts/cell when full.
#5
Senior Member
My Feedback: (325)
Join Date: Mar 2003
Location: LaGrange, OH
Posts: 14,857
Likes: 0
Received 0 Likes
on
0 Posts
RE: Lithium Ion Pack @ 7.8 Fully Charged
I like to toss out all the labels and use the top voltage for description for this very reason. Many li-ions do use 4.2. For the OP just use the voltage termination that the battery calls for and it is the same as "full"
If you thought it was 8.4 then you were probably right and I can't imagine any charger using a "full" label on the 4.2 per cell setting. Chances are good that it terminated the charge for a different reason and the pack isn't "full"
Coincidentally there may be some that use 3.6,3.7 or perhaps even 3.9 as "full" Could you have used the LIFE setting by mistake?
If you thought it was 8.4 then you were probably right and I can't imagine any charger using a "full" label on the 4.2 per cell setting. Chances are good that it terminated the charge for a different reason and the pack isn't "full"
Coincidentally there may be some that use 3.6,3.7 or perhaps even 3.9 as "full" Could you have used the LIFE setting by mistake?
#6
Senior Member
Thread Starter
Join Date: Jul 2012
Location: , CA
Posts: 433
Likes: 0
Received 0 Likes
on
0 Posts
RE: Lithium Ion Pack @ 7.8 Fully Charged
Took a reading off a eter i just bought on the 7.8 pack. It is showing 8.2 on the meter but only 7.8 on the charger. WTH is going on here?
#7
Senior Member
My Feedback: (325)
Join Date: Mar 2003
Location: LaGrange, OH
Posts: 14,857
Likes: 0
Received 0 Likes
on
0 Posts
RE: Lithium Ion Pack @ 7.8 Fully Charged
Obviously one of them is wrong, which one do you trust? Of all the voltmeters and chargers I have I'd say it is a toss-up so I have to check them all.