Byron AT-6 Canopy and Mustang cowl needed
#1
Thread Starter
Byron AT-6 Canopy and Mustang cowl needed
Sent the obligatory email to Iron bay...hoping they will respond. Just in case they don't, does anybody have a line on these parts?
AT-6 Canopy
Mustang Cowl... New version fuse with plug-in wings.
Thanks!
KennyMac
AT-6 Canopy
Mustang Cowl... New version fuse with plug-in wings.
Thanks!
KennyMac
#2
RE: Byron AT-6 Canopy and Mustang cowl needed
http://www.rcuniverse.com/forum/m_10...m.htm#11280456
No promises, but I will try to help on the P-51 cowl. Just a rookie on mold making. First attemt was a disaster on this part. See attached pics. Will try again in another month when the weather here in Michigan is more condusive for mold making and part making.
System wont let me add pics. Too busy. In my forum anyway. Lots of projects, progress is slow.
Edit still wont let me add pics.
No promises, but I will try to help on the P-51 cowl. Just a rookie on mold making. First attemt was a disaster on this part. See attached pics. Will try again in another month when the weather here in Michigan is more condusive for mold making and part making.
System wont let me add pics. Too busy. In my forum anyway. Lots of projects, progress is slow.
Edit still wont let me add pics.
#5
Thread Starter
RE: Byron AT-6 Canopy and Mustang cowl needed
Thanks for the replies. I'll measure the canopy UncleJoe.
Luft, I've got some experience in mold making and different composite layups if you need some help.
KennyMac
Luft, I've got some experience in mold making and different composite layups if you need some help.
KennyMac