Jets & DX18 Tx
#1
Thread Starter
Jets & DX18 Tx
How are you setting up your throttle trim on a turbine using a DX18 (not the QQ edition)?
I assume you are not using the digital trim....?
I ordered a DX18 yesterday and started thinking about this late last night.
Thx,
Steve
I assume you are not using the digital trim....?
I ordered a DX18 yesterday and started thinking about this late last night.
Thx,
Steve
#3
My Feedback: (8)
RE: Jets & DX18 Tx
This is what I use now. http://www.rcuniverse.com/forum/m_11..._1/key_/tm.htm , go to post 24. With this you get full trim in 2 clicks.
I used to use the left slider
I used to use the left slider
#6
Join Date: Mar 2004
Location: ferrara, ITALY
Posts: 1,567
Likes: 0
Received 0 Likes
on
0 Posts
RE: Jets & DX18 Tx
ORIGINAL: Ali
I use the throttle trim and up the value to 10. Works fine for me.
Regards Al
I use the throttle trim and up the value to 10. Works fine for me.
Regards Al
same on my QQ (i use aux channel for emergency shutdown if the receiver have free port)
#10
Thread Starter
RE: Jets & DX18 Tx
Thanks for the replies, very good options!
Ron, I almost bought a 12x, I think it is one fine radio but a little behind with no SD card and still a NiMh battery. The only problem I had was that I'm thinking JR has to be coming with a new Tx soon, maybe 14 or 18 channel... When they do that is what I want so I had a hard time spending the $1200 when I may be replacing it in the near future. The DX18 will handle what I need and if a lose a few bucks when the new top shelf JR comes out so be it.
Steve
Ron, I almost bought a 12x, I think it is one fine radio but a little behind with no SD card and still a NiMh battery. The only problem I had was that I'm thinking JR has to be coming with a new Tx soon, maybe 14 or 18 channel... When they do that is what I want so I had a hard time spending the $1200 when I may be replacing it in the near future. The DX18 will handle what I need and if a lose a few bucks when the new top shelf JR comes out so be it.
Steve
#11
Senior Member
RE: Jets & DX18 Tx
ORIGINAL: bcovish
This is what I use now. http://www.rcuniverse.com/forum/m_11..._1/key_/tm.htm , go to post 24. With this you get full trim in 2 clicks.
I used to use the left slider
This is what I use now. http://www.rcuniverse.com/forum/m_11..._1/key_/tm.htm , go to post 24. With this you get full trim in 2 clicks.
I used to use the left slider