props
#5
Junior Member
Thread Starter
RE: props
Benched a pt 20x13 @114 amps.Same setup on a Mez [email protected]olfly 5320 Tp 5000 8s Turnigy wattmeter Os Esc
#6
RE: props
As Smooth Pass, I also find the PT to draw slightly less than APC on the bench. Is your motor significantly higher kv than the Q (210), possibly a higher rpm explains the difference?
#8
RE: props
I notice that you're running 8S - my experience is w 10S - explains the higher A than I see. However, considering about 3.5v/c at WOT your motor is turning 700-800 more rpm. Maybe the drag profile of the props at the higher rpm is enough to account for your observed measurements. Seems like a bit much prop for 8S.
#9
Junior Member
Thread Starter
RE: props
Your right about it being too much prop.I like the speed of the 20x13 but I have to be careful with throttle management.I think a 20x12 is probably better suited to my setup.