RC10GT steering
#1
Thread Starter
Join Date: Jun 2006
Location: parlier,
CA
Posts: 33
Likes: 0
Received 0 Likes
on
0 Posts
RC10GT steering
I picked up a lightly used rc10gt (flat blue chassis RTR) a week ago... Anyway I was running it last night and busted the steering block I found them on eBay no problem but i wanted to know if the stronger GT2 steering blocks will fit in my GT? Is the a link that shows what parts cross over from GT2 to GT?
#2
Senior Member
Join Date: May 2013
Posts: 223
Likes: 0
Received 0 Likes
on
0 Posts
RE: RC10GT steering
No. Pretty much everything is different on the GT2.
There are a couple of manufacturers of alloy steering blocks for the GT. GPM is one of them, should only run you $15 or $20.
RC10GT was an EXTREMELY popular nitro, and is still supported heavily in the aftermarket. Check out Asiatees.com; Could just about build an all aluminum roller from their catalog.
There are a couple of manufacturers of alloy steering blocks for the GT. GPM is one of them, should only run you $15 or $20.
RC10GT was an EXTREMELY popular nitro, and is still supported heavily in the aftermarket. Check out Asiatees.com; Could just about build an all aluminum roller from their catalog.