Using a Clark Board with Tanker9x firmware?
#1
Thread Starter
Join Date: Nov 2008
Location: Yass NSW, AUSTRALIA
Posts: 208
Likes: 0
Received 0 Likes
on
0 Posts
Using a Clark Board with Tanker9x firmware?
Is anyone out there successfully using a Clark TK22 with a Turnigy 9x radio with either er9x or Tanker9x firmware?
I'm having some issues getting them to play nicely (specifically around turning the tank left or right) and I would be very interested to hear any experiences anybody else has had with this combination.
I'm having some issues getting them to play nicely (specifically around turning the tank left or right) and I would be very interested to hear any experiences anybody else has had with this combination.
#3
Thread Starter
Join Date: Nov 2008
Location: Yass NSW, AUSTRALIA
Posts: 208
Likes: 0
Received 0 Likes
on
0 Posts
RE: Using a Clark Board with Tanker9x firmware?
Issues resolved . I found the source of my problem was mechanical, not radio related. The bearing around one of my drive shafts was slipping under pressure which prevented the tank from turning properly. It was fine in forward and reverse and so it took me a while to find.
I also found setting the throttle value to 50% gives a much smother acceleration/deceleration.
I also found setting the throttle value to 50% gives a much smother acceleration/deceleration.