Pegasus

I am trying to make my throttle trim tab so it only takes 4 clicks or so to move full up and down, for the life of me I can't figure it out, been through the manual and still cannot get it done, can some one help me on this

Dieselman1220

My Feedback: (25)

Go to the t1-t6 setting menu set the throttle trim ( I think it's t3 or t4 don't remember)
to 100 that will give you 4 clicks from full up to full down.

Pegasus

I take it you mean set the rate to 100, I did try that and its not working
I the rate set at 100
mode says atl
and atl reverse reads normal, any idea what I am doing wrong?
Oh yeah and the t3 is flashing

Dieselman1220

My Feedback: (25)

No not atl there is a menu option that says" t1-t6 setting "set the throttle trim tab to 100 default is 4 on all of them. Look at the radio
It's labeled which one it is I don't have mine in front of me to see it. Throttle is either t3 or t4

Pegasus

LOL ok I got it, I was in the wrong menu, thanks for your help.

Dieselman1220

My Feedback: (25)

Great, no prob

Bob_B

My Feedback: (11)

Take it to 200 for the fastest rate change.

Pegasus

I actually did that, I am just use to my 9 cap that does 6 clicks, (I thought it was 4) but for turbines 200 is best on the FGH
Thanks

Bob_B

My Feedback: (11)

Or you can make one of the sliders or knob or well you get the idea the throttle trim. Its easy!