Specktrum receiver problem
#4
My Feedback: (14)
Join Date: Feb 2002
Location: Noblesville,
IN
Posts: 1,503
Likes: 0
Received 0 Likes
on
0 Posts
RE: Specktrum receiver problem
a couple of things I have had to do.
make sure you are not near a metal table, or in a metal building.
make sure you are not near another 2.4 source, like a wifi, micro wave, wireless phone, etc.
move away from the receiver about 4 feet when trying to link.
move to another room, or take all outside and try
just some things I have had to do
make sure you are not near a metal table, or in a metal building.
make sure you are not near another 2.4 source, like a wifi, micro wave, wireless phone, etc.
move away from the receiver about 4 feet when trying to link.
move to another room, or take all outside and try
just some things I have had to do
#6
My Feedback: (20)
Join Date: Jun 2009
Location: LaGrange,
GA
Posts: 544
Likes: 0
Received 0 Likes
on
0 Posts
RE: Specktrum receiver problem
Steve may have it, a lot of folks have reported binding problems when standing too close. Have you tried binding from across the room? I've read that the power signal overloads the RX sometimes if you're too close.
#8
Senior Member
Join Date: May 2008
Location: Northern Occupied Mexico,
CA
Posts: 998
Likes: 0
Received 0 Likes
on
0 Posts
RE: Specktrum receiver problem
I turn off the fluorescent shop lights when I bind also.
I've had a few that have given me trouble. Turn off lights and then Bind no problem.
I've had a few that have given me trouble. Turn off lights and then Bind no problem.
#9
Senior Member
Thread Starter
My Feedback: (4)
Join Date: Feb 2009
Location: Anderson,
SC
Posts: 384
Likes: 0
Received 0 Likes
on
0 Posts
RE: Specktrum receiver problem
I've tried all of the above before I posted. I believe I'll have to change the receiver. It does not seem that the satellite should bind and not the receiver if it was good.
#11
Senior Member
Join Date: Jan 2011
Location: SorrentoBritish Columbia, CANADA
Posts: 2,018
Likes: 0
Received 0 Likes
on
0 Posts
RE: Specktrum receiver problem
I had the same trouble when using a 4 cell battery.. I plugged in a 5 cell and the problem went away.. My 4 cell was my bench battery.. Older battery...