An (Electric) f rotating wing
#1
Thread Starter
Join Date: Aug 2010
Location: Lynn,
MA
Posts: 451
Likes: 0
Received 0 Likes
on
0 Posts
An (Electric) f rotating wing
A New twist to an Old concept! I've had some time to work on 2nd prototype Need it to Promote it as a Unit to be Powered by anE.V. Using the Auto as a Cockpit see 1st prototype Better pic. on Twitter Charles Glazebrook 1st working Prototype! Hope I can get some Positive Reactions Out there?
#4
Senior Member
Join Date: Aug 2008
Location: Spanaway,
WA
Posts: 784
Likes: 0
Received 0 Likes
on
0 Posts
RE: An (Electric) f rotating wing
Not impressed that you use a forum that will allow pictures to redirect people to twitter or facebook to look at pictures, especially when you make comments like "Need it to Promote it" .
You've been here three years, you should know how to post pics by now.
You've been here three years, you should know how to post pics by now.
#5
Thread Starter
Join Date: Aug 2010
Location: Lynn,
MA
Posts: 451
Likes: 0
Received 0 Likes
on
0 Posts
RE: An (Electric) f rotating wing
It is a (Wing in a Propellor Configuration) Turned by a Typhoon Motor on Both sides Facing in opposite Directions! Hope you understand Now Needs no tail rotor.Please see picture and you will understand! See a Better Pic. on Twitter of 1st prototype?2nd has 8 ft. Rotating wing 4ft. on each side with a typhoon motor on each side to pull it around Will have 2nd Done soon and will get it in flight on Video Hope you catch on? They did it in the 50s with Jrt tip Rotor Blades! This is a Larger Surface area on each side and does not have to Rotate as Fast to Produce the Same amount of Lift! You will see on Video Thanks Charlie
#11
Thread Starter
Join Date: Aug 2010
Location: Lynn,
MA
Posts: 451
Likes: 0
Received 0 Likes
on
0 Posts
Please let me Know if anybody did'nt get a Picture of My 1st prototype I thought it was Simple to explain Guess Not? You Tube has a Video you Must see.? Young 1 Heli. concepts.Bell Heli. beginnings For something with no c.g. and no Control surfaces it flew like a Kite with no Tail.He could have tied it to a Brick until control problems got worked out? Oh it Lifted fine Not turning upside down until it got to about 30 ft No Dihedral Nothing?
#12
Senior Member
Join Date: Nov 2009
Location: Glendale,
AZ
Posts: 1,034
Likes: 0
Received 0 Likes
on
0 Posts
I think I need a bigger picture and possibly a video. The picture is too small to see what is going on. I still don't quite understand the concept based on the current information.
#13
Thread Starter
Join Date: Aug 2010
Location: Lynn,
MA
Posts: 451
Likes: 0
Received 0 Likes
on
0 Posts
I should have a Video of it soon.Need speed control for both Brushless motors.1st prototype had Brush motors with only 2 leads?Need 1 to control Both Motors.It actually works like a Car Horn.With tilt and turn capabilitys! Does that Help you Understand?1st only had a 3ft. by 6 inch wing on each side with cheap Brush Motors But, it Worked!
Last edited by charlie111; 07-14-2014 at 01:53 PM. Reason: spell error
#14
Thread Starter
Join Date: Aug 2010
Location: Lynn,
MA
Posts: 451
Likes: 0
Received 0 Likes
on
0 Posts
Wondering if any of you Folks out there have any Old Helicopter parts Kicking around? I'll try to explain How it Works! Large Wings instead of Blades,Battery for each motor (In) Wing near center,3 contacts (Brushses) at Hub from Receiver to e.s.c.s Before (Split)!1st.prototype worked with fixed pitch.But I would like to have a collective for Auto rotating.If you haven't seen Hiller & Bell video you should.Started with motors & props (Just like Mine!) Funny But I didn't see video until after starting My project.His prop. driven version Lifted perfectly! But had nothing to comtrol Flight No c.g. or control surfaces.Just some diheadral? would have helped to Stabilize it.So, It went up & Over like a Kite without a Tail?Rotary wingspan is just over 6' by11"