Integy Suspension Arms
#1
Senior Member
Thread Starter
My Feedback: (4)
Join Date: Feb 2009
Location: Middleburg,
FL
Posts: 516
Likes: 0
Received 0 Likes
on
0 Posts
Integy Suspension Arms
I recently purchased a set of Integy control arms for my Emaxx. After I got it assembled I noticed a problem with clearance between the drive shafts at the point where the steering knuckle attaches at full up. They are suppose to work with stock driveshafts. http://www.ebay.com/itm/380672135772...84.m1497.l2648
Anyone else experience this? This pic is with the truck sitting on all 4 wheels.
Thanks
Anyone else experience this? This pic is with the truck sitting on all 4 wheels.
Thanks
#2
Member
Join Date: Nov 2009
Location: kings mountain,
NC
Posts: 47
Likes: 0
Received 0 Likes
on
0 Posts
RE: Integy Suspension Arms
Get out the dremel tool or buy a set of cvd's. Seems like they would know but typical of integy though..send them back get another set them could be defective..just trying to help..hope u get it worked out