Blades loses track after aerobatics... Perfect while hovering
#1
Junior Member
Thread Starter
Join Date: Jul 2013
Location: , MI
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
Blades loses track after aerobatics... Perfect while hovering
Hey guys,
I have a 50 size hirobo shuttle sceadu evolution with a gv-1 governor, carbon fiber blades, and an O.S .55 SZ engine.
While hovering in normal mode, the blades track beautifully. Furthermore, when I switch to idle up mode in a hover, everything stays perfectly aligned. However, after inverted maneuvers or very agressive flying, the blades are horribly mis-aligned. They are off-track by an inch and a half. Switching to normal mode and landing fixes the problem.
What could this be? Sorry if the answer is obvious. I'm still a bit new to helicopters.
Some background information about this helicopter. I bought it used from a 3D pilot 4 years ago. It flew perfect 2 years ago, but I stored it in my basement for 2 years and haven't touched it since.
Thanks again guys,
abc23023
I have a 50 size hirobo shuttle sceadu evolution with a gv-1 governor, carbon fiber blades, and an O.S .55 SZ engine.
While hovering in normal mode, the blades track beautifully. Furthermore, when I switch to idle up mode in a hover, everything stays perfectly aligned. However, after inverted maneuvers or very agressive flying, the blades are horribly mis-aligned. They are off-track by an inch and a half. Switching to normal mode and landing fixes the problem.
What could this be? Sorry if the answer is obvious. I'm still a bit new to helicopters.
Some background information about this helicopter. I bought it used from a 3D pilot 4 years ago. It flew perfect 2 years ago, but I stored it in my basement for 2 years and haven't touched it since.
Thanks again guys,
abc23023
#4
Junior Member
Thread Starter
Join Date: Jul 2013
Location: , MI
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
RE: Blades loses track after aerobatics... Perfect while hovering
Thanks guys!
Does anyone know where I could buy dampers? My local hobby store didn't have any that fit my spindle.