Rocketman612

My Feedback: (85)

I have a Futaba 12z that has been converted to 2.4 with the TM-14 module and software download. I am trying to bind a Futaba R6014FS Rx and am having problems. The 12z is set to "Mult FASST" with a solid green light on the TM-14 unit and is turned on first. Then the Rx is turned on with the easy link depressed. I get flashing red and green light for several seconds then I release and get a flashing GREEN light. I have done this several times with the same result. My understanding is that this means the Rx is seeing the FASST signal it's just not linked to it. Any help appreciated.

Also I still have not gotten any info on the Futaba Flyers Club.

Thanks,
Pete

Rocketman612

My Feedback: (85)

Got it bound. No worries


Pete

Bax

My Feedback: (11)

We're glad to hear you got it sorted out. What was the difficulty? Not holding the link button long enough?

Rocketman612

My Feedback: (85)

Not sure. I held the button down for a 2 one thousand count each time. Go figure.

Still need to get into the Flyers Club to look into some programming on my 12z. Sent in the info but never got a response [&o]

Pete

LSP972

My Feedback: (13)

Same here. I got my 12Z for Xmas, sent in the info mid-January. Haven't heard anything.

.