OS 300 GEMINI TWIN CONVERSION
#1
Thread Starter
My Feedback: (5)
Join Date: Sep 2003
Location: Walton,
KY
Posts: 197
Likes: 0
Received 0 Likes
on
0 Posts
OS 300 GEMINI TWIN CONVERSION
I have an OS 300 twin Gemini engine that I am thinking of
converting to gas. Has anyone on this forum done this? How involved is
the process, is it worth the effort? Can someone give me a place to start
the process? thanks Aframe2
converting to gas. Has anyone on this forum done this? How involved is
the process, is it worth the effort? Can someone give me a place to start
the process? thanks Aframe2
#2
My Feedback: (1)
Join Date: Jan 2002
Location: Riverton,
WY
Posts: 3,114
Likes: 0
Received 0 Likes
on
0 Posts
RE: OS 300 GEMINI TWIN CONVERSION
Start here. Then call and talk to him.
http://ch-ignitions.com/index.php
http://ch-ignitions.com/index.php
#3
My Feedback: (4)
RE: OS 300 GEMINI TWIN CONVERSION
The stock carburetor will be VERY difficult to adjust while using gas. The flow will be about 1/3 of nitro based fuel so getting a good needle set will not be easy.
Buy the new Saito 57T. It is fantastic! I have one and it runs like a swiss watch (Rolex).
#4
Senior Member
My Feedback: (4)
Join Date: Jan 2004
Location: Blackfoot ,
ID
Posts: 2,251
Likes: 0
Received 0 Likes
on
0 Posts
RE: OS 300 GEMINI TWIN CONVERSION
I have done the conversion's to the baby brother 160 with good success. Is it worth it ? the man I did it for thought so, but I didn't *L*
#5
Thread Starter
My Feedback: (5)
Join Date: Sep 2003
Location: Walton,
KY
Posts: 197
Likes: 0
Received 0 Likes
on
0 Posts
RE: OS 300 GEMINI TWIN CONVERSION
Thanks tkg, Tbatt, and Cyberwolf. I think it is a little too involved for me, so I
will just run it the way it is, and clean up the mess. Thanks again, Aframe2
will just run it the way it is, and clean up the mess. Thanks again, Aframe2