Need help Jet Tronic single brake valve and DX18
08-01-2013, 06:37 PM
#1
Thread Starter
Need help Jet Tronic single brake valve and DX18
I have a single Jet Tronic brake valve on the right lever on my DX18.. if the lever is not all the way up I lose air... I'm looking for a mix to "in-activate" the brake channel when my gears are retracted. A mix that I tried puts the brake channel at nuteralI, then in that case i will be losing air since its half way.. I know i can use UP6, BVM Smooth stop or the low loss jetronic brake valve, but I would like to make what I have do the job with a mix... Help is appreciated
08-01-2013, 07:17 PM
#2
Join Date: Nov 2006
Location: yorba linda,
CA
Posts: 595
Likes: 0
Received 0 Likes
on
0 Posts
RE: Need help Jet Tronic single brake valve and DX18
On the function screen set the control to null.
Then create a programmed mix the right lever as the master and the.brake.channel as a slave.
In logic make it active when the gear down switch is active. You can use different line functions so the brake valve only goes to extremes with no intermediate points. If you dont get.enough trave you can add an identical programmed mix that will double the travel.
Cheers,
Steve
Then create a programmed mix the right lever as the master and the.brake.channel as a slave.
In logic make it active when the gear down switch is active. You can use different line functions so the brake valve only goes to extremes with no intermediate points. If you dont get.enough trave you can add an identical programmed mix that will double the travel.
Cheers,
Steve
