Disc Camo Stenciles in 1/16?
#1
Thread Starter
Disc Camo Stenciles in 1/16?
Before I try making making my own my own in 1/16 scale, I thought I'd take the easy way out and see if anyone had a source for these as "store boughts".
They are listed from some outfits in 1/48 and 1/35, but I have not seen any in 1/16.
They are listed from some outfits in 1/48 and 1/35, but I have not seen any in 1/16.
#2
RE: Disc Camo Stenciles in 1/16?
I haven't done any measuring yet but was going to look into using a hole punch.
I would at least start there.
Jeff
I would at least start there.
Jeff
#3
RE: Disc Camo Stenciles in 1/16?
I bet there are easily found circles (like the looseleaf hole reinforcing stickies) that are the right size, if you planned it carefully, you could nail the look.
#4
RE: Disc Camo Stenciles in 1/16?
Glen, you could buy the 1/35 set and then spray black on a sheet of paper or card stock and then blow the image up to 1/16 on a copier? I did the same thing with some 1/35 decals to make stencils of them in 1/16. Airbrushed turret numbers are a beautiful thing!!!
#8
RE: Disc Camo Stenciles in 1/16?
Some have used different size round erasers dipped in paint .
Jimmy
Jimmy
#12
RE: Disc Camo Stenciles in 1/16?
I would still try blowing up the 1/35 scale stencils to 1/16?
#13
Thread Starter
RE: Disc Camo Stenciles in 1/16?
ORIGINAL: MAUS45
I would still try blowing up the 1/35 scale stencils to 1/16?
I would still try blowing up the 1/35 scale stencils to 1/16?
#14
RE: Disc Camo Stenciles in 1/16?
Looking at the picture, it looks to me like they shot the dark color, then laid out paint can lids, then shot a light color, then pulled the lids and shot a bit more of the light color in blobs.
I bet you could do that. To scale. More or less.
It would sure look cool.