X-Cellerator 24.7 + front/rear wing
#1
Senior Member
Thread Starter
Join Date: Jul 2005
Location: Crystal Lake,
IL
Posts: 309
Likes: 0
Received 0 Likes
on
0 Posts
X-Cellerator 24.7 + front/rear wing
Just felt like showing off my XTM X-Cellerator. I have a modified XTM 24.7 (.25ci) engine, and front and rear wing, and numerous other upgrades. This thing will blow away a Jata 3.3 garaunteed. It can pull wheelies very easily, and it tops out around 65-70mph.
Before front wing install:
After front wing install:
Before front wing install:
After front wing install:
#6
Senior Member
Thread Starter
Join Date: Jul 2005
Location: Crystal Lake,
IL
Posts: 309
Likes: 0
Received 0 Likes
on
0 Posts
RE: X-Cellerator 24.7 + front/rear wing
The truck is a single speed. If it wasn't for the Jato nobody would even need to ask that question lol. I ordered the front wing from Tower, its the front wing from a Megatech dragster. The installation took a while, and a lot of creativity. The rear wing was much easier to install, but still took some modding to the wing mounts. The stock X-Cellerator clutch bell is a 15 tooth, and I am running a 23 tooth, which is why the truck is so fast. I can't even get to full speed without the front end kicking up, and that's WITH the front wing. I might try to shift some of the weight foward a little bit. I have video too, just need to host it.
#8
Senior Member
RE: X-Cellerator 24.7 + front/rear wing
ORIGINAL: Bombers_410
Yes post that vid man! Looks sweet. I'm thinking about getting an x-cellerator, where did u get the rear wing?
Yes post that vid man! Looks sweet. I'm thinking about getting an x-cellerator, where did u get the rear wing?