Saito 220 Problems
#1
Thread Starter
My Feedback: (69)
Join Date: Oct 2005
Location: Henderson,
NV
Posts: 52
Likes: 0
Received 0 Likes
on
0 Posts
Saito 220 Problems
Ok guys, here it is. I am trying to get my 220 to idle. Anything under 2500 rpm and it dies. I have used a 20x6 Zinger, 20x8w APC and 22x10 Mejzlik. 20-20 fuel and Saito plug. I tried a Perry Pump with little change. Checked the pushrod clearance, cleaned the carb and reset both needles. Asking help with this for the sake of my Goldberg 77' Yak. My next step will be a onboard glo driver. Saito 220 drivers.....HELP!
Thanks,
Roy
Thanks,
Roy
#4
Senior Member
My Feedback: (1)
Join Date: Sep 2004
Location: STOCKHOLM Akersberga, SWEDEN
Posts: 1,116
Likes: 0
Received 0 Likes
on
0 Posts
RE: Saito 220 Problems
Your props seems to be too big for your new 220. I would recommend an APC 18x8 or APC 19x8 too let her break in without overheating. Maybe overheating is causing it to die.
Idle just below 2000rpm should not be any problem for a big saito. Your idle needle is probably very rich or slightly lean. If the engine runs fine and idles at a lower rpm with the glow batteri connected then you need to lean the idle needle slightly. Let us know how it goes.
Idle just below 2000rpm should not be any problem for a big saito. Your idle needle is probably very rich or slightly lean. If the engine runs fine and idles at a lower rpm with the glow batteri connected then you need to lean the idle needle slightly. Let us know how it goes.
#6
Senior Member
My Feedback: (4)
Join Date: Jul 2002
Location: Canton,
MI
Posts: 2,914
Likes: 0
Received 0 Likes
on
0 Posts
RE: Saito 220 Problems
I am able to idle my Saito 220 w/ Biela 20x6 CF prop at about 2100 rpm. It took me a while to find the idle screw position that will result in a reliable idle.
When I switched to 30% nitro heli fuel, it helped my idle a little better.
When I switched to 30% nitro heli fuel, it helped my idle a little better.
#8
Junior Member
Join Date: Jan 2006
Location: virginia beach,
VA
Posts: 23
Likes: 0
Received 0 Likes
on
0 Posts
RE: Saito 220 Problems
Anyone having vibration issues? My 220 wont keep the muffler attached, it even shook the stock muffler in two! PLEASE HELP!!!!!!!!!!!!!!!!!!
Thanks,
Chris
Thanks,
Chris
#9
Senior Member
My Feedback: (4)
Join Date: Jul 2002
Location: Canton,
MI
Posts: 2,914
Likes: 0
Received 0 Likes
on
0 Posts
RE: Saito 220 Problems
ORIGINAL: torque wrench
Sean, how is your top rpm with that setup, supposedly my Just Engines 20x6 carbon fibre prop is a copy of your Biela, Thanks
Sean, how is your top rpm with that setup, supposedly my Just Engines 20x6 carbon fibre prop is a copy of your Biela, Thanks
7800 rpm on 20/20
7100 rpm on 5% nitro