XTM 18 in RS4??
#1
Member
Thread Starter
Join Date: Apr 2006
Location: Esco,
CA
Posts: 91
Likes: 0
Received 0 Likes
on
0 Posts
XTM 18 in RS4??
Would an XTM 18 fit easily into the RS4 EVO?? Reason I ask is because this enginge would be free to me if it fits, but if its too much work its not worth it. Its the version that comes stock in the XTM X-cellerator. Thank you.
#3
Senior Member
RE: XTM 18 in RS4??
a shaft like this (take the nut off and that little aluminum peice) its a threaded shaft
http://www2.towerhobbies.com/cgi-bin...&I=LXGGP7&P=ML
http://www2.towerhobbies.com/cgi-bin...&I=LXGGP7&P=ML
#4
Member
Thread Starter
Join Date: Apr 2006
Location: Esco,
CA
Posts: 91
Likes: 0
Received 0 Likes
on
0 Posts
RE: XTM 18 in RS4??
Looks like the XTM should fit perfectly then... know of a good "cheap" header for that engine, [link=http://www.hobbypeople.net/gallery/146002.asp]XTM Engine[/link] . Remember I am only doing this because my t-15 is dead, and this engine seems to run strong in the x-cel, and is free to me. Thank you for the help!!
#6
Join Date: Mar 2004
Location: Brampton,
ON, CANADA
Posts: 2,469
Likes: 0
Received 0 Likes
on
0 Posts
RE: XTM 18 in RS4??
#7
Join Date: Jan 2006
Location: sauk city,
WI
Posts: 226
Likes: 0
Received 0 Likes
on
0 Posts
RE: XTM 18 in RS4??
it fits! Just went right in, I'll run it tomarow and let you know how it goes. This xtm enging has about 6 gallons thru it. Not too strong anymore but bullet proof.