NZAP Cessna Agwagon 120"
#1
Junior Member
Thread Starter
Join Date: Nov 2006
Location: GeelongVic, AUSTRALIA
Posts: 9
Likes: 0
Received 0 Likes
on
0 Posts
NZAP Cessna Agwagon 120"
Has anyone in this forum built and flown the 120"Cessna Agwagon available from NZAP plans.
I would like to know if you built it and flew it ok with the incidence angles shown on the plans.
That is 3 degrees downthrust on engine 1.5 degrees positive on the wing and 4 degrees negative
tail incidence.
Thanks for all replies.
I would like to know if you built it and flew it ok with the incidence angles shown on the plans.
That is 3 degrees downthrust on engine 1.5 degrees positive on the wing and 4 degrees negative
tail incidence.
Thanks for all replies.
#2
My Feedback: (1)
Join Date: Jun 2002
Location: Casablanca, CHILE
Posts: 94
Likes: 0
Received 0 Likes
on
0 Posts
RE: NZAP Cessna Agwagon 120"
Hi
I have the same plans and fiberglass parts since 5 years ago , I hope to begin the construction soon.
I will order a complete laser cut package from a kit cutter cutter in USA, if you want we can share some info and tips of this kit.
Regards
Fernando V.
I have the same plans and fiberglass parts since 5 years ago , I hope to begin the construction soon.
I will order a complete laser cut package from a kit cutter cutter in USA, if you want we can share some info and tips of this kit.
Regards
Fernando V.