Notices
Engine Conversions Discuss all aspects of engine conversions in this forum

Reversing weedeater engine direction?

Old 07-07-2007, 07:39 PM
  #1  
jester_s1
Moderator
Thread Starter
 
Join Date: Dec 2006
Location: Fort Worth, TX
Posts: 7,266
Received 35 Likes on 30 Posts
Default Reversing weedeater engine direction?

I've got a 30cc engine out of my busted wacker. I got it out and torn down only to figure out the next day that it runs clockwise from the front. The question is if I figure out an ignition setup can I run this engine counterclockwise without damaging it? The crank doesn't look offset and it's a reed valve engine.
I can post pics of anything if needed.
Old 07-07-2007, 07:53 PM
  #2  
av8tor1977
My Feedback: (6)
 
av8tor1977's Avatar
 
Join Date: May 2003
Location: Tucson, AZ
Posts: 7,217
Likes: 0
Received 2 Likes on 2 Posts
Default RE: Reversing weedeater engine direction?

It will run backwards with no problems, if you get the ignition setup properly.

If you want to stay with spark ignition, the easiest way would be to use electronic ignition from www.ch-ignitions.com. The sensor mount can easily be put where you want it to run in either direction.

Another way would be to go with what we call "Gas/Glow". It uses a special fuel mix, and a glow plug and can easily run in either direction with no mods.

AV8TOR
Old 07-07-2007, 08:32 PM
  #3  
jester_s1
Moderator
Thread Starter
 
Join Date: Dec 2006
Location: Fort Worth, TX
Posts: 7,266
Received 35 Likes on 30 Posts
Default RE: Reversing weedeater engine direction?

I've read up on both of those. Some people have said that the Walbro carbs aren't too happy with alcohol though. I'd rather not have to tear this thing down every season.
Is there anything wrong with keeping the stock ignition and altering the flywheel to change the timing? It's set with a woodruff key so I could mill a new slot it easily.
Old 07-07-2007, 09:17 PM
  #4  
Ralphbf
My Feedback: (27)
 
Ralphbf's Avatar
 
Join Date: Mar 2004
Location: Woodland, CA
Posts: 1,450
Likes: 0
Received 0 Likes on 0 Posts
Default RE: Reversing weedeater engine direction?

Actually it's the Zama carbs that don't like Gas-Glow.

Walbro carbs are very happy with the Gas-Glow mix.
Old 07-07-2007, 09:21 PM
  #5  
Antique
Senior Member
My Feedback: (4)
 
Antique's Avatar
 
Join Date: Jul 2002
Location: Somewhere, DC
Posts: 9,825
Likes: 0
Received 0 Likes on 0 Posts
Default RE: Reversing weedeater engine direction?

Buy a pusher prop......
Old 07-08-2007, 06:10 PM
  #6  
captinjohn
 
Join Date: Jan 2002
Location: Hesperia Michigan, MI
Posts: 12,957
Received 4 Likes on 4 Posts
Default RE: Reversing weedeater engine direction?

Jester: What are you going to put this engine in? What you use it in could make a difference!!! Capt,n
Old 07-09-2007, 08:04 AM
  #7  
jester_s1
Moderator
Thread Starter
 
Join Date: Dec 2006
Location: Fort Worth, TX
Posts: 7,266
Received 35 Likes on 30 Posts
Default RE: Reversing weedeater engine direction?

I haven't decided yet. I'm a new flyer and only have a .40 sized trainer now. I'm only messing with this thing now because I have it already and was tired of stepping over the whacker in my shed. I'm thinking some kind of basic sport flyer though once I feel like I'm ready for it, or maybe a warbird.
Old 07-15-2007, 03:53 PM
  #8  
Mitty
 
Mitty's Avatar
 
Join Date: Oct 2003
Location: Jackson, MS
Posts: 474
Likes: 0
Received 0 Likes on 0 Posts
Default RE: Reversing weedeater engine direction?


ORIGINAL: jester_s1

I've read up on both of those. Some people have said that the Walbro carbs aren't too happy with alcohol though. I'd rather not have to tear this thing down every season.
Is there anything wrong with keeping the stock ignition and altering the flywheel to change the timing? It's set with a woodruff key so I could mill a new slot it easily.
Hello.
IMHO It's easier to take 4 screws out and put a new 2-dollar diaphragm in carburetor then mill something down and play with timing just to find out later that you missed something and ruined the engine. OR buy a pusher prop
Old 07-15-2007, 06:47 PM
  #9  
lane279
 
Join Date: Jul 2007
Location: Benbrook, TX
Posts: 14
Received 0 Likes on 0 Posts
Default RE: Reversing weedeater engine direction?

Okay, if your engine runs the opposite way and you install one of these CH ignitions how do you go about making it run opposite? Is it covered in the instructions?



Layne...
Old 07-15-2007, 06:50 PM
  #10  
tkg
My Feedback: (1)
 
Join Date: Jan 2002
Location: Riverton, WY
Posts: 3,114
Likes: 0
Received 0 Likes on 0 Posts
Default RE: Reversing weedeater engine direction?

You time it for the direction you want it to run.

ORIGINAL: lane279

Okay, if your engine runs the opposite way and you install one of these CH ignitions how do you go about making it run opposite? Is it covered in the instructions?



Layne...
Old 07-15-2007, 07:14 PM
  #11  
lane279
 
Join Date: Jul 2007
Location: Benbrook, TX
Posts: 14
Received 0 Likes on 0 Posts
Default RE: Reversing weedeater engine direction?

Don't want to come across as stupid, so I'm going to read up on this lol



Layne...
Old 07-15-2007, 08:10 PM
  #12  
dirtybird
My Feedback: (5)
 
Join Date: Jan 2002
Location: San Tan Valley, AZ
Posts: 5,768
Likes: 0
Received 0 Likes on 0 Posts
Default RE: Reversing weedeater engine direction?


ORIGINAL: lane279

Don't want to come across as stupid, so I'm going to read up on this lol



Layne...
Gee thats a novel approach
Old 07-15-2007, 10:41 PM
  #13  
captinjohn
 
Join Date: Jan 2002
Location: Hesperia Michigan, MI
Posts: 12,957
Received 4 Likes on 4 Posts
Default RE: Reversing weedeater engine direction?

You want the engine to fire about 29 degrees before top dead center. Since 360 is top dead center..I think you can subtract 29 from 360...which is 331 degrees. If you think about it more you will get the Idea. Or use a degree wheel for oppisite rotation. Best Regards Capt,n
Old 07-15-2007, 10:56 PM
  #14  
lane279
 
Join Date: Jul 2007
Location: Benbrook, TX
Posts: 14
Received 0 Likes on 0 Posts
Default RE: Reversing weedeater engine direction?

Thanks captinjohn appreciate the help! Wow dirtybird, that seemed kinda harsh there, but I'm sure I took it the wrong way.



Layne...
Old 07-15-2007, 11:34 PM
  #15  
Ralphbf
My Feedback: (27)
 
Ralphbf's Avatar
 
Join Date: Mar 2004
Location: Woodland, CA
Posts: 1,450
Likes: 0
Received 0 Likes on 0 Posts
Default RE: Reversing weedeater engine direction?

For $35.00 CH will set it up for you.
Send them the engine and a check and forget the head and the heart aches.
Old 07-26-2007, 12:24 AM
  #16  
KI8FR
Senior Member
 
KI8FR's Avatar
 
Join Date: Feb 2004
Location: Ovid, MI
Posts: 976
Likes: 0
Received 1 Like on 1 Post
Default RE: Reversing weedeater engine direction?

The bad thing about doing this is. The prop hub can unscrow.. wach it.. it will come off and hit you.
Paul

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Thread Tools
Search this Thread

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.