Cut GYRO wire
08-05-2007, 02:50 PM
#1
Junior Member
Thread Starter
Join Date: Jun 2007
Location: Forsyth, GA
Posts: 28
Likes: 0
Received 0 Likes
on
0 Posts
Cut GYRO wire
I cut a wire on my GYRO. A JR G500T. Can you repair the wire, or replace it???? I just don't feel like buying another 150.00 dollar GYRO.
Anyone have this happen?? Or know a solution
Anyone have this happen?? Or know a solution
08-05-2007, 03:11 PM
#2
RE: Cut GYRO wire
If you are confident in your wiring skills I'd say repair it. If not than any radio or avionics or similar shop, or even a battery shop or something similar should have someone with the soldering skills to repair it in short order.
If not then send it to Radio South http://www.radiosouthrc.com
The last one I sent to Futaba they checked it out after a crash, replaced a cracked case and a nicked wire and it cost me about 35 dollars including parts, labor, and return shipping.
If not then send it to Radio South http://www.radiosouthrc.com
The last one I sent to Futaba they checked it out after a crash, replaced a cracked case and a nicked wire and it cost me about 35 dollars including parts, labor, and return shipping.
08-06-2007, 12:45 PM
#4
Senior Member
My Feedback: (1)
Join Date: Dec 2004
Location: Mechanicsville,
VA
Posts: 919
Likes: 0
Received 0 Likes
on
0 Posts
RE: Cut GYRO wire
Solder a splice in it. Alot of giant scale guys don't like the connectors on servo extensions so they cut the plugs off their servos and extensions and solder them all the time.
