os18 starting issues
#1
Junior Member
Thread Starter
Join Date: Dec 2007
Location: Wesley Chapel, FL
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
os18 starting issues
i have a 1st gen rs4 that i recently upgraded to an os18 motor. i got it started enough to run two tanks through to break it in, and today i got it started to run a third into, then when i tried to start it again the pull starter was very hard to pull at all and i couldnt get it started again. any input is greatly appreciated.
thanks
motor is brand new out of box.
thanks
motor is brand new out of box.
#2
Senior Member
Join Date: Jun 2007
Location: Neiden, NORWAY
Posts: 162
Likes: 0
Received 0 Likes
on
0 Posts
RE: os18 starting issues
you engine is problaby flooded... take the glow plug out and pull the starter(fuel should spit out of the plughole). and screw the plug back.
if its still hard to pull. loosen the plug a little. and when it starts thighten it ....
if its still hard to pull. loosen the plug a little. and when it starts thighten it ....
#5
Senior Member