How do I safely get a .21 running again that never had After-run ran through it about a year ago?
#1
Junior Member
Thread Starter
Join Date: Jun 2008
Location: , MD
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
How do I safely get a .21 running again that never had After-run ran through it about a year ago?
Hey guys,
I have a Hyper .21 that has been sitting for a year after I wrecked my inferno pretty badly. I am ready to install the engine again, but I never ran afterrun through it after the wreck. Of course now when I turn the engine over by hand, it feels like it is turning through syrup!
What is the safest way to get this engine going again?
Thanks!
I have a Hyper .21 that has been sitting for a year after I wrecked my inferno pretty badly. I am ready to install the engine again, but I never ran afterrun through it after the wreck. Of course now when I turn the engine over by hand, it feels like it is turning through syrup!
What is the safest way to get this engine going again?
Thanks!
#2
Senior Member
Join Date: Jan 2007
Location: hampton,
GA
Posts: 779
Likes: 0
Received 0 Likes
on
0 Posts
RE: How do I safely get a .21 running again that never had After-run ran through it about a year ago?
take off the backplate and soak it in a little nitro to clean it out
#3
Senior Member
Join Date: Nov 2007
Location: Richmond Hill,
NY
Posts: 114
Likes: 0
Received 0 Likes
on
0 Posts
RE: How do I safely get a .21 running again that never had After-run ran through it about a year ago?
take the engine apart and clean it all up, then put it back together and it should start right up
#4
Senior Member
Join Date: Nov 2007
Location: , NEW ZEALAND
Posts: 221
Likes: 0
Received 0 Likes
on
0 Posts
RE: How do I safely get a .21 running again that never had After-run ran through it about a year ago?
yip... pull it right down give it all a clean... put it back together lubing with WD40.... whack a new plug in and ya should be good to go