brake problem need help
#1
Member
Thread Starter
Join Date: Jun 2007
Location: killdeer, ND
Posts: 35
Likes: 0
Received 0 Likes
on
0 Posts
brake problem need help
I was getting ready to run again and noticed my disk brake separated from my drive shaft cup. Also I only have front wheels turning the gear box. How do I get the disk back on the cup and have 4 wheel drive again?
#2
Senior Member
Join Date: Dec 2007
Location: Starkville,
MS
Posts: 472
Likes: 0
Received 0 Likes
on
0 Posts
RE: brake problem need help
check it shaft cup and make sure it is tight i had the same problem with mine intill i took the spur assm.. out and noticed it was loose so it just sat there and spin w/o turn the wheels, and for the brake while u have the tranny housiing out u should be able to take the brakes apart and slide the rotor back on then install the brake back on.. pictures would help
#3
Senior Member
Join Date: Jan 2008
Location: Perham,
MN
Posts: 554
Likes: 0
Received 0 Likes
on
0 Posts
RE: brake problem need help
the simplest fix and most often the problem of loosing front or rear wheel drive is that one of the many drive cup grub screws has come loose. make sure you use loctite on them
#4
Member
Thread Starter
Join Date: Jun 2007
Location: killdeer, ND
Posts: 35
Likes: 0
Received 0 Likes
on
0 Posts
RE: brake problem need help
Will red loctite work? Thats what I have on hand and what i used to put the pull start back on after vibrating off. Ill try to get pics after work Is there anything that holds the disk in place?
#6
Member
Thread Starter
Join Date: Jun 2007
Location: killdeer, ND
Posts: 35
Likes: 0
Received 0 Likes
on
0 Posts
RE: brake problem need help
I'll pick up some blue. I got everything apart but I need new set screws what size are the ones that go in the drive shaft cup?