Throttle Arm for FS-91 Surpass II?
#1
Member
Thread Starter
Join Date: Oct 2002
Location: Derby, KS,
Posts: 39
Likes: 0
Received 0 Likes
on
0 Posts
Throttle Arm for FS-91 Surpass II?
Hi,
I need a throttle arm for my FS-91 Surpass II, and I can't find a part number for it in the owners manual. This is literally the arm that the throttle pushrod attaches to. It screws onto the sleeve with a single phillips screw. Can anyone tell me what the part number is and where to get it? Is there an alternate part I can use?
Thanks,
Jay
I need a throttle arm for my FS-91 Surpass II, and I can't find a part number for it in the owners manual. This is literally the arm that the throttle pushrod attaches to. It screws onto the sleeve with a single phillips screw. Can anyone tell me what the part number is and where to get it? Is there an alternate part I can use?
Thanks,
Jay
#2
Senior Member
RE: Throttle Arm for FS-91 Surpass II?
http://www3.towerhobbies.com/cgi-bin...=OSMG2432&P=OW
Check the engine parts listing and it is a 60P carb
then again on the O.S. parts list, down near the bottom of the list is carbs and there you will find the break down of the parts
Don
Check the engine parts listing and it is a 60P carb
then again on the O.S. parts list, down near the bottom of the list is carbs and there you will find the break down of the parts
Don
#3
Member
Thread Starter
Join Date: Oct 2002
Location: Derby, KS,
Posts: 39
Likes: 0
Received 0 Likes
on
0 Posts
RE: Throttle Arm for FS-91 Surpass II?
Thanks Don! Looking at the Tower page (http://www3.towerhobbies.com/cgi-bin...&I=LXCW25&P=OW), it's listed as an "O.S. Throttle Lever 120Surpass". It wasn't clear that it would fit the 91FSII, but I see now from the OS parts list that they call it the same thing.
Jay
Jay
#4
Senior Member
RE: Throttle Arm for FS-91 Surpass II?
Jay, a lot of the parts are used on several engines. IE on the Magnum line, the main needle valve is the same on almost all, if no all, the engines both 2 stroke and 4 strokes.
Don
Don