icors2

So I got a engine mod on my rtx-1 and now my car goes in reverse when I give it gas and forward when I push reverse. I tried to change the engine around but if I did that it would break the engine. So what can Ido so this goes faster again. I read on the main site that there is a way to change the reverse and forward signals but how do you do that??? Can somebody please help me out with this. Thanks to whoever answers in advance.

Druss

You need to reverse the throttle servo on your radio.

icors2

And how do you do that?

teacher brent

You hooked up your motor wires backward. The fat wires that go from your speed control to your motor. Unplug them (2) and switch them. It will run the right way. Have fun.

Druss

There is a switch for both throttle and steering on the transmitter that say "nor" and "rev", change the throttle one.

icors2

What is the switch on im not a master at this just so you know most of these words out not in my vocabulary thanks for the help though. But I couldnt find the switch on my radio controler, so i looked inside the car the best guess I could make is its on the thing that moves the car right and left is that right and where on it is it. Cause I took it out and didnt see it on there also. Did notice that the wires on the engine are backwards from what the original motor was so what exactly do i need to do ????thanks for all this help

Druss

Reversing the motors wires will work too. What exactly is this? Sounds like it's not a hobby grade if you don't even have a nor-rev switch.

icors2

its the Radline platinum series rc rtx-1, and im not sure if i do just couldn't find it on the remote control where exactly would it be? would switch the wires but i dont have any sadder.