Allgood_73

The other day I figure I would make a couple of RPM purchases from Stormer Hobbies and I bought the following:

		Part #		Description		Qty		B/o		Price Ea.			Ext. Price
		<tt>DYN0910</tt>		Mach 427/Mach 26 O-Ring Set (6)		1				<tt>$6.95</tt>			<tt>$6.95</tt>
		<tt>RPM73255</tt>		LST Head Guard, Blue for Mach .26 engine		1				<tt>$3.95</tt>			<tt>$3.95</tt>
		<tt>RPM73335</tt>		LST Gear Cover and Backing Plate, blue		1				<tt>$9.95</tt>			<tt>$9.95</tt>

Is the gear cover for the LST not the same one as for the LST2?!?! When I drive the truck, it's grinding against the inner cover and will soon eat through.

Here's the link to the one I bought: https://www.ssl-stormerhobbies.com/c...ns&pn=RPM73335



Also, is the head gaurd not the same size for the Mach 427? It's way too small and I ended up having to zip tie it on.

ARDV8

I think RPM covers do rub unless you modify them.

Allgood_73

Thanks for the response. So does rubbing hurt anything?

Also, it sucks the Head Guard doesn't fit... on RPM's site, it says that it will fit the LST2 (second product in the link below):
http://www.rpmrcproducts.com/products/losi/LSTParts.htm

Sugafree

does any one have a fix for rpm gear cover

full maxx

still on the stock cover ...where you been sugafree

Allgood_73

Thanks for the linksugafree... i wish I would have saw that a week ago before I ordered this crap that they say "fits LST2". No more ordering RPM products for me. Thanks again.

Sugafree

Been Busy Working the last few Weeks.......Haven't had much time to check out the Forums.......(But once I get Caught up....I'll be around like Normal)

animalnut

thankfully I run aluminum side rails that sit dead flush with the top and bottom plates so the cover works for me but only due to after market rails![:@]
After reading the quote from rpm that cover will be the last piece of there product on my truck!