Servo mounting for 3D
#1
Member
Thread Starter
Join Date: Jul 2006
Location: edinburg, VA
Posts: 63
Likes: 0
Received 0 Likes
on
0 Posts
Servo mounting for 3D
When setting up a foamie for 3D, is it better to keep the elev and rudder servos close to the CG or close to the elev and rudder?
Thanks
Jonathan
Thanks
Jonathan
#5
Junior Member
My Feedback: (3)
Join Date: Jul 2008
Location: pinckney,
MI
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
RE: Servo mounting for 3D
put your servos as close to the cg as u can without having to add weight to the tail the plane will fly th best with its weight around the cg, but on such a small light plane you will have to comprimise a little to get it to balance. i usually install servos last, i tape them in place untill i find a good location to achive the desired cg. if you r battery location moves do this with the battery centered that way u can adjust the cg fore and aft after first flights to dial in the cg
#6
RE: Servo mounting for 3D
IMO, putting the servos about 2-3" behind the wing on most foamies yields a better moving foamy. More mass around the tail will allow it to whip around better in spins