Servos for 1/3 scale Sig Spacewalker?
#1
Thread Starter
Join Date: Sep 2003
Location: Fremont,
CA
Posts: 72
Likes: 0
Received 0 Likes
on
0 Posts
Servos for 1/3 scale Sig Spacewalker?
I'm putting finishing touches on a 1/3 scale Sig Spacewalker. The plane has a 104" wingspan and weights around 20 lbs and is powered by a Zenoah G-38.
Anyone have suggestions on servos?
I was thinking about using the following servos:
Hitec HS-475HB (61 oz-in torque) on each ailron
Hitec HS-645MG (107 oz-in torque) on the rudder
Hitec HS-645MG (107 oz-in torque) on the elevator (one servo for the entire elevator)
Will these servos be sufficient?
Thanks,
Greg
Anyone have suggestions on servos?
I was thinking about using the following servos:
Hitec HS-475HB (61 oz-in torque) on each ailron
Hitec HS-645MG (107 oz-in torque) on the rudder
Hitec HS-645MG (107 oz-in torque) on the elevator (one servo for the entire elevator)
Will these servos be sufficient?
Thanks,
Greg
#2
My Feedback: (180)
RE: Servos for 1/3 scale Sig Spacewalker?
No. Those would be on the lowest end for torque that one would consider. I would suggest at least 100oz/in for each aileron. 200oz in for the elev/rudder. Use all metal gear servos as the vibration from a gas engine will produce significant slop in a servo.
#3
My Feedback: (1)
Join Date: Mar 2005
Location: Farmington,
WV
Posts: 635
Likes: 0
Received 0 Likes
on
0 Posts
RE: Servos for 1/3 scale Sig Spacewalker?
Greg,
Those will be just fine. I'm guessing you're not going to be 3Ding the plane... :-) I would suggest that you use two 645's on the elevator though...
Good Luck and enjoy...!
Ed
Those will be just fine. I'm guessing you're not going to be 3Ding the plane... :-) I would suggest that you use two 645's on the elevator though...
Good Luck and enjoy...!
Ed
ORIGINAL: GregG7
I'm putting finishing touches on a 1/3 scale Sig Spacewalker. The plane has a 104'' wingspan and weights around 20 lbs and is powered by a Zenoah G-38.
Anyone have suggestions on servos?
I was thinking about using the following servos:
Hitec HS-475HB (61 oz-in torque) on each ailron
Hitec HS-645MG (107 oz-in torque) on the rudder
Hitec HS-645MG (107 oz-in torque) on the elevator (one servo for the entire elevator)
Will these servos be sufficient?
Thanks,
Greg
I'm putting finishing touches on a 1/3 scale Sig Spacewalker. The plane has a 104'' wingspan and weights around 20 lbs and is powered by a Zenoah G-38.
Anyone have suggestions on servos?
I was thinking about using the following servos:
Hitec HS-475HB (61 oz-in torque) on each ailron
Hitec HS-645MG (107 oz-in torque) on the rudder
Hitec HS-645MG (107 oz-in torque) on the elevator (one servo for the entire elevator)
Will these servos be sufficient?
Thanks,
Greg