Bulldog or Punisher body ST-RR
#1
Junior Member
Thread Starter
Join Date: Jan 2009
Location: prospect hill, NC
Posts: 20
Likes: 0
Received 0 Likes
on
0 Posts
Bulldog or Punisher body ST-RR
Has anyone heard if they are making the new bodies ( Prolineline Bulldog or Jconcepts Punisher) for the Kyosho ST-RR or has anyone fit a different make (d8t,rc8t,2.0,mbx6t) of these bodies onto the ST-RR? I need a new body for the new race season.
#3
Senior Member
RE: Bulldog or Punisher body ST-RR
Mounting issues though, right?? I'd like the Proline one for my RC8T, but I think you have to get the Jconcepts mount, disassemble the whole rear end, and drill new holes in the shocktowers...
#5
Junior Member
Thread Starter
Join Date: Jan 2009
Location: prospect hill, NC
Posts: 20
Likes: 0
Received 0 Likes
on
0 Posts
RE: Bulldog or Punisher body ST-RR
I would see that the rear body mounts would not be a problem and i could adjust it to any height, but the front? Will the body sit as low as it should? And is the RC8t body the correct width for the ST-RR mud guards?
#7
Junior Member
Thread Starter
Join Date: Jan 2009
Location: prospect hill, NC
Posts: 20
Likes: 0
Received 0 Likes
on
0 Posts
RE: Bulldog or Punisher body ST-RR
The measurement for the width of the mud guards would help me be sure if the Bulldog or the Punisher might fit. The ST-RR is about 210mm across. Im sure it is close to the same. Now i only need to make sure if the front shock tower will let me sit the body low like it is desinged.
#8
Senior Member
Join Date: Aug 2009
Location: isanti, MN
Posts: 190
Likes: 0
Received 0 Likes
on
0 Posts
RE: Bulldog or Punisher body ST-RR
i forgot to mesure last night. but the front tower wont be a problem as for the mounts are on top, just drill some holes. The back you can just move the mounts down on the tower by drilling new holes, and trimm the body to fit.
#9
Junior Member
Thread Starter
Join Date: Jan 2009
Location: prospect hill, NC
Posts: 20
Likes: 0
Received 0 Likes
on
0 Posts
RE: Bulldog or Punisher body ST-RR
Thanks for all the help. I just hate to buy the RC8T bulldog body if they are going to make one for the ST-RR. But i can't wait so i'll just try it. Thanks again.