laganm21

Hey i just picked up a used NTC3 and I wanted to put a OS 18TZ in bumpstart, My question is what shaft do I buy the short shaft and use a pilot, or a long shaft, http://www3.towerhobbies.com/cgi-bin...&I=LXHLV6&P=SM, http://www3.towerhobbies.com/cgi-bin...I=LXHLV9&P=SMi know the 2nd one is a rotery carb, i was just showing the difference in the shafts

k20_94_dc

My Feedback: (2)

good luck on ntc3 help around here

mgreen

Long. Why are you putting a .18 in it? .12 is more than enough for the NTC3.

k20_94_dc

My Feedback: (2)

Bigger is always better

Igotntc3andrevo

You want the one with the pilot shaft and slide carb, if you go with the short shaft/rotary carb you will need the shaft extender.

Igotntc3andrevo

Ive been away for years on this forum has the nitro tc3 died out?

k20_94_dc

My Feedback: (2)

I guess I can't get much help on here I recenetly picked up a ntc3 roller and want to put a tz in it. I have never had a team asociated b4 so I'm kinda lost haha I've always had hpi but the rs4 with a tz wasn't fast enought

Igotntc3andrevo

O ok well I murdered HPI's with my tc3 and the .18 tz I had so long as you get the one with the pilot shaft and slide carb you should be good to go....gearing is where the fun is next.

k20_94_dc

My Feedback: (2)

Cool man thanx a lot what gearing did u run? And did u ever race any 4tec 3.3?

Igotntc3andrevo

honestly I dont remember what it was but I do remember I had to keep the gap (amount of teeth) equal between first and second, But I learned I was able to "cheat" a little and went with the largest pinion possible against the smallest spur but first gears pinion I went one tooth down and was still able to keep the Mesh and not strip out the gears.

Ate them up with my T.Z but my tc3 is pretty modded

k20_94_dc

My Feedback: (2)

Niice yea laganm21 that started this post has a 3.3 and I'm trying to beat him but he's pretty good with these so its gonna be a good battle but at least my 1/5 scale is fast than his haha

Igotntc3andrevo

lol it shouldnt take to much wrk unless he is running a modded 3.3 then you may be in a bit of trouble

Rcrunnerine

ntc3 roller rocks.

D.DJ

If he wants a modded 3.3, I can help with that : )

k20_94_dc

My Feedback: (2)

He actually did a mod his self seems to have done a good job but haven't had a chance to really run it he just got done with the break in