zubee1

This video was taken Sat 3-13 during the test session in Huntsville...
The boat is the prototype JAE gas boat with a "box stock" RCMK rear exhaust motor....[the motor is turning 16,600 rpm]
The only smooth water was right in front of the drivers stand....this video does not do justice as to how rough the water was during this test run.
The new JAE gas boat does absolutely nothing stupid in any water conditions....
This run was with a Voodoo 7520 prop......We have several 3" plus diameter props coming to try and all indications are that 75mph
will be attainable with this JAE/"box stock" RCMK combo.....[we haven't even set the head clearance in this motor yet]
We have another gas boat prototype in construction and the same tests will be run with a "box stock" 260 Zenoah....

http://www.youtube.c...h?v=Oav0nqHRIhU

Note:Once again,the only adjustments required on this boat are prop selection,pipe length and needle valve....

martno1fan

The links not working mate.

cheesewizz69

I couldn't make it work for me either. Also looks like a duplicate post. He has the same post/link on the GF

http://www.rcuniverse.com/forum/fb.asp?m=9589223

martno1fan

Yea its allways a good idea to check your links after posting them ,cant find anything on utube either least not under gas JAE rigger .
Mart

noahdear

My Feedback: (2)

Googled it ... [link]http://www.youtube.com/watch?v=Oav0nqHRIhU[/link]

martno1fan

Clever ****** lol............Looks promising is Joe at zipp going to release a kit for the gas one ?.
Mart

Ron Olson

My Feedback: (1)

BUOY CUT TURN 6!!!!!!
Bill, that's actually what we need to see is some rough water running to show what it can do in less than ideal or race conditions.
Hopefully Joe's got me up towards the top of the list.

zubee1

Yes the wind was blowwing ptretty hard at times. Plus rain and Hail too. Even had a radio glitch that sent the boat into the shore luckily it didn't hurt anything too bad.

martno1fan

So are you testing these kits out for Joe ? when are the kits available and how much lol.
Mart

zubee1

I'm helping David Hall test his design bfore it goes to Joe for kitting that way we know the design is proven especially since we are using a stock RCMK engine tod the testing next one will be using a stock Zenoha so everyone will have a good comparison between the engines.

martno1fan

Cheers ill look forward to seeing how you get on.

Ron Olson

My Feedback: (1)

The easy way to view the video.............
[youtube]http://www.youtube.com/watch?v=Oav0nqHRIhU[/youtube]