how do i fit my failsafe?
05-29-2010, 03:31 PM
#3
Senior Member
Join Date: Mar 2008
Location: San Diego but living in Dubai, UNITED ARAB EMIRATE
Posts: 4,857
Likes: 0
Received 0 Likes
on
0 Posts
RE: how do i fit my failsafe?
Well, it's been a while, but I believe you place it between power supply and receiver. Did it not come with instructions?
05-29-2010, 03:50 PM
#4
RE: how do i fit my failsafe?
i thought they went between the RX and the throttle/brake servo. so if there is a loose of radio signal it moves the servo to the brake position.
05-29-2010, 04:17 PM
#5
Senior Member
Join Date: Aug 2006
Location: Bristol, UNITED KINGDOM
Posts: 3,444
Likes: 0
Received 0 Likes
on
0 Posts
RE: how do i fit my failsafe?
ORIGINAL: nitrosportsandrunner
i thought they went between the RX and the throttle/brake servo. so if there is a loose of radio signal it moves the servo to the brake position. [sm=thumbs_up.gif]
i thought they went between the RX and the throttle/brake servo. so if there is a loose of radio signal it moves the servo to the brake position. [sm=thumbs_up.gif]
it goes between the throttle servo and the receiver
05-30-2010, 05:32 AM
#8
Senior Member
Join Date: May 2009
Location: antwerpen, BELGIUM
Posts: 1,968
Likes: 0
Received 0 Likes
on
0 Posts
RE: how do i fit my failsafe?
I have a venom fail safe and it goes between the battery and reciever, it'll close the throttle servo and straighten out the wheels if the battery power is to low or I loose signal.
