Zman39

My Feedback: (6)

Hello,

I have a little f-16 that flys on ailevators. I been trying to get things moving right direction for a couple days now and still no success. I was hoping you could give me a good head start so to speak. Right now, I am in airplane mode and for tail I choose ailvator. What channels should the 2 servos be plugged into? ANy help much appreciated.

Thx

Z

Bax

My Feedback: (11)

You just need to look at the servo monitor and then move the elevator stick. It will show you which channels are using the elevator and elevator2 functions. The channels will change depending upon the wing type.

Don't forget to set how much aileron-type movement you want on the elevators. You need to go into the Ailevator section of the Model Menu to get that part set up.

Zman39

My Feedback: (6)

thanks for the reply Bill. When I set it up and I pulled elevator, they went in different directions. Do I change this in reversing or in ailevator menu with the + and -?

Bax

My Feedback: (11)

Use the + and - in the ailevator menu. Otherwise, it would mess up the elevator function and then cause you to have to re-do the ailevator mixer anyway.