Zagi 400x - Where to plug ESC ?
#1
Junior Member
Thread Starter
Join Date: Jul 2002
Location: Gatineau, QC, CANADA
Posts: 16
Likes: 0
Received 0 Likes
on
0 Posts
Zagi 400x - Where to plug ESC ?
I can't get the motor to run on my new Zagi 400x... The servos work OK but no power to the motor. In which channel should I plug the ESC (Hitec electron6)? Should it be in the Bat or in the Throttle channel ? This is probably a stupid question because it's not specified in the instructions (or I'm not finding it)
Bruno
Bruno
Bruno
Bruno
#2
Senior Member
My Feedback: (2)
Join Date: Jun 2002
Location: Minot,
ND
Posts: 276
Likes: 0
Received 0 Likes
on
0 Posts
RE: Zagi 400x - Where to plug ESC ?
In the throtle postion ! then advance the throtle to full and wait for a couple seconds and back to idle and then advance it again ! may need to energize the esc its a saftey feature most esc have ! hope this helps
#4
Junior Member
Thread Starter
Join Date: Jul 2002
Location: Gatineau, QC, CANADA
Posts: 16
Likes: 0
Received 0 Likes
on
0 Posts
RE: Zagi 400x - Where to plug ESC ?
Ahhhhhhh. Good to know the few seconds at full throttle procedure. Then it make a few bips.
It works !
Thanks
Bruno
It works !
Thanks
Bruno