12FGA flight conditions
03-09-2012, 04:29 AM
#1
Thread Starter
Join Date: Aug 2006
Location: Lynn Haven, FL
Posts: 124
Likes: 0
Received 0 Likes
on
0 Posts
12FGA flight conditions
My 12 FGA radio is driving me crazy. I use flight conditions on my old 9ZAP. This 12 ch radio will not allow me to program it. I call up the flight conditions screen and assign a switch. I then name the new condition and I choose "single" for the function of the ail and elev channels. Then I go to end points screen, I bring up the #2 condition and program more elev travel. However, that new amount of travel winds up being in both conditions and I cannot isolate it out for the #2 condition. As I look at the end point screen, I move the switch to the two flight conditions but no where on the screen does it indicate that my condition screen is changing. What is wrong?
03-09-2012, 07:19 AM
#2
Thread Starter
Join Date: Aug 2006
Location: Lynn Haven, FL
Posts: 124
Likes: 0
Received 0 Likes
on
0 Posts
RE: 12FGA flight conditions
hello Futaba. Please ignore my email. I finally figured it out. When changing travel on the various conditions, the user must use AFR to limit the servo movement. I was using "end points" and that will not work. Now my radio is working fine.
