Futaba 14mz 2.4mhz binding new receiver question
07-25-2012, 05:44 AM
#1
Member
Thread Starter
My Feedback: (29)
Join Date: Jul 2004
Location: Stockbridge,
GA
Posts: 41
Likes: 0
Received 0 Likes
on
0 Posts
Futaba 14mz 2.4mhz binding new receiver question
I bought a used Futaba 14mz tranmitter and want to bind a new receiver. Can someone tell me where I can find instructions on how to bind the new receiver? Thanks
07-25-2012, 10:40 AM
#2
Join Date: Jan 2003
Location: Champaign, IL
Posts: 3,796
Likes: 0
Received 0 Likes
on
0 Posts
RE: Futaba 14mz 2.4mhz binding new receiver question
What is the new receiver that you have?
Sincerely,
Krysta
Product Development & Support Specialist
Futaba Service Center USA
[email protected]
Sincerely,
Krysta
Product Development & Support Specialist
Futaba Service Center USA
[email protected]
07-25-2012, 05:22 PM
#4
Join Date: Jul 2011
Location: Newport Beach, CA
Posts: 44
Likes: 0
Received 0 Likes
on
0 Posts
RE: Futaba 14mz 2.4mhz binding new receiver question
Hello,
Very easy, go to linkage menu, choose Frequency then choose FASST 7CH not FASST MULT as any RX 7 or below uses the 7CH anything above the 7mark goes to the FASST MULT. No need to punch in numbers or anything like that, I have 6 planes on the R617FS with no issues. Just leave the TX on and push the button between the antena, it might take a few tries but it will go green. Hope this helps.
Steve
Very easy, go to linkage menu, choose Frequency then choose FASST 7CH not FASST MULT as any RX 7 or below uses the 7CH anything above the 7mark goes to the FASST MULT. No need to punch in numbers or anything like that, I have 6 planes on the R617FS with no issues. Just leave the TX on and push the button between the antena, it might take a few tries but it will go green. Hope this helps.
Steve
07-27-2012, 06:06 AM
#5
My Feedback: (11)
RE: Futaba 14mz 2.4mhz binding new receiver question
You set the transmitter to 7-channel mode in the Frequency section of the Linkage menu. Then turn off the transmitter. Now, you turn on the transmitter, turn on the receiver, and hold the link button on the receiver. The LED will go from flashing green to solid green.
