Me410

I have two strong coreless digital servos in the tail of my plane, one for each elevator. I need to Y-harness AND reverse one servo. I have a Futaba reverser model SR10. But I have been advised by an Aircraft RC retail store that I should not use this reverser with digital servos, as problems can happen with the reversed servo, like slow response, or intermittent movement.

I need to know what the deal is here as I have at least $2500.00 invested in this plane and can't risk elevator problems.

Using another channel and mixing with the elevator channel is not an option as I am out of channels. My radio is a Futaba T8FG.

Thanks for any help on this
Tom

Krysta

We are not sure why they have given you information like this.

The SR10 works fine for both Analog and Digital servos, with no lack of response or problems with speed.

FEATURES: Perfect for use on large-scale aircraft that require two servos on
one control surface.
Delivers precision control without the need for special mixing
from the transmitter.
The center pot centers on the servo reverser centers both servos
Along with an RF noise filter that eliminates interference.

COMMENTS: A super accessory for dual elevator servos, dual flaps and twin-
engine models- as well as in conjunction with Futaba's new
GYA aircraft gyros.

This will work on digital as well as analog servos.


Sincerely,
Krysta
Product Development & Support Specialist
Futaba Service Center USA
[email protected]

Me410

Thanks for the quick support Krysta.