Buka

hi guys

i am having alil problem when i mix my rudder servos to the elevator ... well actually i get this if i mix any 2 chanes the servos sop moving smoothly ... its as if i am moving them wit a ratchet ??? why is this i am using a 14mz transmiter the 14 channel reciver and 9451 servos ... it also occurs when i move the elevator and rudder at the same time with no mixing ???

please help

Bax

My Feedback: (11)

If you move the sticks or sliders slowly-enough, you may see this. That's because there are discrete steps in the signal processins. It will be more noticeable in PPM mode, and less so in PCM 1024 and PCM 2048 modes.