Servo Suitability.
#1
Senior Member
Thread Starter
Join Date: May 2007
Location: , NEW ZEALAND
Posts: 370
Likes: 0
Received 0 Likes
on
0 Posts
Servo Suitability.
Hi,
I have several Futaba 9255, and 9252 servos, new in the boxes, and wish to use them in my new jet plane project, Rookie 11, for elevons x 4, and cannards and vector nosil---
Are these servos good for the job ???
Also are they ok with 5.9 volt regulated power supply ?????
Power wise they are fine, but they are listed as heli servos and i just wish to conferm they are ok---
Thank you in advance,
Jay.
I have several Futaba 9255, and 9252 servos, new in the boxes, and wish to use them in my new jet plane project, Rookie 11, for elevons x 4, and cannards and vector nosil---
Are these servos good for the job ???
Also are they ok with 5.9 volt regulated power supply ?????
Power wise they are fine, but they are listed as heli servos and i just wish to conferm they are ok---
Thank you in advance,
Jay.
#2
Join Date: Jan 2003
Location: Champaign, IL
Posts: 3,796
Likes: 0
Received 0 Likes
on
0 Posts
RE: Servo Suitability.
Hi Jay,
You should be fine using these in your jet. According to Futaba they are compatible with Nitro planes.
As long as the voltage is regulated to 5.9V, they will be fine.
Sincerely,
Krysta
Product Development & Support Specialist
Futaba Service Center USA
You should be fine using these in your jet. According to Futaba they are compatible with Nitro planes.
As long as the voltage is regulated to 5.9V, they will be fine.
Sincerely,
Krysta
Product Development & Support Specialist
Futaba Service Center USA
ORIGINAL: Sonicwings
Hi,
I have several Futaba 9255, and 9252 servos, new in the boxes, and wish to use them in my new jet plane project, Rookie 11, for elevons x 4, and cannards and vector nosil---
Are these servos good for the job ???
Also are they ok with 5.9 volt regulated power supply ?????
Power wise they are fine, but they are listed as heli servos and i just wish to conferm they are ok---
Thank you in advance,
Jay.
Hi,
I have several Futaba 9255, and 9252 servos, new in the boxes, and wish to use them in my new jet plane project, Rookie 11, for elevons x 4, and cannards and vector nosil---
Are these servos good for the job ???
Also are they ok with 5.9 volt regulated power supply ?????
Power wise they are fine, but they are listed as heli servos and i just wish to conferm they are ok---
Thank you in advance,
Jay.