New 6014
#2
My Feedback: (11)
RE: New 6014
We'd have no idea. There is too little information. If you have a wireless computer network in the house, it can interfere. You may have other strong sources of 2.4 GHz radiation locally. You may have a bad transmitter. You may have a bad receiver. Did you properly perform the link procedure?
Any number of reasons.
Any number of reasons.
#3
Thread Starter
RE: New 6014
Thanks for the reply Bill.
No wireless computer link,
No 2.4 radiation,
I have linked it correctly I have an old used 6014 working faultlessly beside the new one. Still get the flashing green led and no servo control.
Incidentally if I switch the transmitter off the led shows solid red. Switch it back on green begins flashing??
m
No wireless computer link,
No 2.4 radiation,
I have linked it correctly I have an old used 6014 working faultlessly beside the new one. Still get the flashing green led and no servo control.
Incidentally if I switch the transmitter off the led shows solid red. Switch it back on green begins flashing??
m