10 CAG 2.4 flap adjustments
08-18-2010, 09:16 PM
#1
Senior Member
Thread Starter
My Feedback: (6)
Join Date: Nov 2007
Location: chanhassen,
MN
Posts: 263
Likes: 0
Received 0 Likes
on
0 Posts
10 CAG 2.4 flap adjustments
I am looking at buying a radio with more channels. I have the following question about this radio.
If you are using two servoes for a flap installation and using channel #6 can this radio adjust each INDIVIDUAL flap servo in the following ways?
Trim
Neutral point
Endpoint
Reverse throw
It appears that it can not.
If you are using two servoes for a flap installation and using channel #6 can this radio adjust each INDIVIDUAL flap servo in the following ways?
Trim
Neutral point
Endpoint
Reverse throw
It appears that it can not.
08-20-2010, 01:46 PM
#2
My Feedback: (11)
RE: 10 CAG 2.4 flap adjustments
Channel 6 does not have trim, but you can adjust centering with subtrim and you can adjust the endpoints and direction. If you are operating two servos off of a single channel, you cannot adjust the servos separately, unless you're using a device like the MSA-10 Servo Synchronizer. That allows adjustment of direction, centering and endpoints of up to four servos on a single channel.
