Gasser Set Up question
Hello
I got a 50cc with a wolverine switch with 3 JR connector output and on the pervious system I plugged each JR output into a Y harness on one end and a servo on the other end. My question is if I can set up my plane using the same system with a R6208SB. Is the channel8/B the only power imput or can I use any channel or in my case 3 channels for power imput. Also how many amps can the receiver bus handle. |
RE: Gasser Set Up question
You can use any servo connection for power input. They are all connected in common for power. One is marked "B" because there are users who have to have a battery port marked or they'll stress over using something else.
Figure on a max of 8 Amps on the receiver bus. |
All times are GMT -8. The time now is 11:47 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.