Fuji 43 .... need a couple of parts
#1
Thread Starter
My Feedback: (14)
Join Date: Dec 2002
Location: Birmingham,
AL
Posts: 994
Likes: 0
Received 0 Likes
on
0 Posts
Fuji 43 .... need a couple of parts
I have the Fuji 43 and I need the fiber part that goes between the prop and the crank.. it is like sand paper and is a disk shape... Also would like the mounting bolt that is drilled so that a spinner can be installed...
Would really like any suggestions on these two items as to what can I do to if the parts are not available... thanks...
Would really like any suggestions on these two items as to what can I do to if the parts are not available... thanks...
#4
My Feedback: (16)
TOWER still has just a few parts but not the ones you are looking for.
You will just have to be resourceful? Use sand paper for the prop bushing.
Figure out the thread size on your crankshaft and you can use one made for a different engine? I had a friend tap a regular bolt for me in a lathe for the spinner screw on my Zenoah G62,
You will just have to be resourceful? Use sand paper for the prop bushing.
Figure out the thread size on your crankshaft and you can use one made for a different engine? I had a friend tap a regular bolt for me in a lathe for the spinner screw on my Zenoah G62,